Step by Step Installation and Configuration Cellular Network and IoT Devices to Secure our Home This video is a continuation of our Project to Implement Smart City devices. We will add a cellular network for our smart phones to connect and install IoT devices to secure our Home. So let’s get down to it. Step 1 - Installation and Configuration Cellular Network a. Install and Connect Layer 3 switch (3650-24PS), as shown.1. ISP/Telco, GigabitEthernet6/0 to Multilayer Switch0, GigabitEthernet1/0/1 with Straight Through cable. b. Install Central Office Server on top of the table and connect the backbone port to the Multilayer switch..1. Multilayer Switch0, GigabitEthernet1/0/1 to Central Office Server, Backbone Port. c. Configure ISP Router Interface 6/0 as shown1. Assign Interface 6/0 with 10.5.0.1 IP Address d. Configure the Central Office Server, as shown.1. IP address - 10.5.0.22. Default Gateway - 10.5.0.13. DNS Server - 10.2.0.1254. DHCP - use DNS above and Save e. Rename the L3 Switch and verify G1/0/1 and G1/0/24 are up. f. Install and connect Cell Towers to ISP/Central Office Server, as shown1. Cell tower 1 to Central Office Server, Coaxial12. Cell tower 2 to Central Office Server, Coaxial33. Cell tower 3 to Central Office Server, Coaxial24. Cell tower 4 to Central Office Server, Coaxial0 g. Install and configure SmartPhone and verify connection to Cell Tower.1. Place the SmartPhone within the green shaded circle to indicate you are in range of the Cell Tower.2. Click Logical mode to see the graphical connection. You will see two Smartphones. The second is inside our Home Network. Step 2 - Installation and Configuration of IoT Devices. a. Install the following IoT Devices 1. Front Door2. Garage Door3. Motion Detector4. Siren5. Front Camera
